This package will transform the power delivery of your Sherco 300, it will suit the following models:

Sherco 300 SE Factory Models 2018-2025

Sherco 300 SE Racing Models 2019-2025

The kit includes the following:

• A new 2 piece TSP Billet machined cylinder head with a replaceable combustion chamber insert in Low, Medium, or High Comp. See below for more detailed explanations of each compression ratio.
• A Handheld touchscreen ERM device which comes with a free downloadable TSP ECU Tune to suit your bike & relevant TSP modifications (For a full breakdown of this product CLICK HERE)
• A ERM wiring harness with wired in relay to power the ERM unit
• A new NGK spark plug, better suited to the improved power the engine makes with this kit
• A new carby needle which provides much better fueling at part throttle than any of the needles in the stock spares kit. We will also provide a starting guide for the main jet and pilot jet. The original spares kit should contain the necessary main and pilot jets required to jet your bike to suit the TSP Power Kit. If you don’t have the original jet kit and need main and pilot jets then just ask and we can add them to your order.

This package makes a huge difference to the Sherco 300 and offers the following gains over a stock bike:

• Much more torque at low/mid revs, where you need it most.
• Drastically improved 0-1/2 throttle performance.
• 2 ignition maps: hard and soft. The stock map switch works like normal to select between the customised maps.
• Much smoother, crisper power deliver which is easier to get to the ground.
• Much less ‘pipe bang’… this is the annoying “dang, dang, dang” noise the engine makes on deceleration. Its generally harmless but very annoying and makes some stock bikes unpleasant to ride at times.
• Better throttle response.
• Better fuel economy.
• More peak power and overrev.
• You can ride in a higher gear with lower revs in many situations and use the extra low end torque to get you places with less wheel spin and much less clutch work.

This package has been tested and raced by some of the best riders in the world and the feedback has been excellent. Everyone from factory level riders to weekend trail riders have reported a significant increase in performance and rideability.

There is no change to reliability with this setup… the ignition maps, air fuel ratios and combustion chamber designs are similar to those we have run very successfully for years on modified carb models, as a result we know exactly what it can or cant handle in terms of performance mods.

Combustion chamber designs:

LOW COMPRESSION – This head was designed to suit extreme enduro riding or for riders who are more interested in smoothness over power gain. It offers stronger bottom end torque than stock with a very smooth delivery that wont break traction too easily. It enables the rider to use lower revs and less clutch when tackling hard obstacles. The low comp design also offers maximum resistance to overheating in tough situations.

MEDIUM COMPRESSION – This head  suits the majority of trail riders and racers who want better bottom and mid power and a gain up top as well. The power delivery is much stronger and more tractable than stock and suits a wide range of riding conditions. Suited to 95 or 98 RON fuel (approx 89 or 91 in the USA).

HIGH COMPRESSION – This head suits riders who want harder hitting power everywhere, especially down low, and are happy to sacrifice some overrev to achieve this. It completely transforms the bike into a weapon, but can be a handful in some situations at sea level. It can also be used at higher elevation (above 1000m) to achieve a similar power delivery to the medium compression head at sea level. Must use with 98 RON fuel at sea level (approx 91 in the USA). We don’t recommend using this design for extreme enduro due to the increased tendency to overheat in very tight, technical riding near sea level, or for high revving applications like desert racing or supermoto… best to use the low or med designs for those applications.